Test: PLASTICS PIPING SYSTEMS-POLYETHYLENE (PE) PIPES- TEST METHOD FOR THE RESISTANCE TO INTERNAL PRESSURE AFTER APPLICATION OF SQUEEZE-OFF (TS EN 12106)

• Test
‣ Determination of Density
‣ MFR
‣ OIT
‣ Determination of Carbon Black
‣ Pigment or Carbon Black Dispersion
‣ Determination of Tensile Properties
‣ Resistance to Internal Pressure
‣ Determination of Volatile Content
‣ Determination of Dimensions
‣ Determination of Longi. Reversion
‣ Oven Test
‣ Determination of Ring Stiffness
‣ Determination of Ring Flexibility
‣ Resistence to External Blows
‣ Determination of the tensile strength and failure mode of test pieces from a butt-fused joint
‣ Peel Decohesion Test for Polyethylene (PE) Electrofusıon Assemblies Of Nominal Outside Diameter
‣ Crushing Decohesion Test for Polyethlene (PE) Electrofusion Assemblies
‣ Decohesion Test of Polyethylene (PE) Saddle Fusion Joints-Evaluation of Ductility of Fusion Joint Interface by Tear Test
‣ Tightness Tests of Valves
‣ Determination of Resistance to Rapid Crack Propagation (RCP)
‣ Determination of Resistance to Crack Propagation
‣ Carbon Black Content In Olefin Plastics
‣ Metallic Materials-Tensile Testing
‣ Plastics Piping Systems – Crosslinked Polyethylene (Pe-X) Pipes – Determination Of Degree Of Crosslinking By Solvent Extraction
‣ Plastics Piping And Ducting Systems – Injection- Moulded Thermoplastics Fitting – Methods For Visually Assessing The Effects Of Heating
‣ Plastics Piping Systems-Polyethylene (Pe) Pipes- Test Method For The Resistance To Internal Pressure After Application Of Squeeze-Off
‣ Determinatıon Of Tear Strenght
‣ Plastics And Ebonite – Determination Of Indentation Hardness By Means Of A Durometer (Shore Harness)
‣ Determination Of Hardness - Part 7: Apparent Hardness Of Rubbercovered Rollers By Shore Type Durometer Method
‣ Gully Tops And Manhole Tops For Vehicular And Pedestrian Areas - Part 1: Definitions, Classification, General Principles Of Design, Performance Requirements And Test Methods
‣ Gully Tops And Manhole Tops For Vehicular And Pedestrian Areas - Part 2: Gully Tops And Manhole Tops Made Of Cast Iron
‣ Gully Tops And Manhole Tops For Vehicular And Pedestrian Areas - Part 5: Gully Tops And Manhole Tops Made Of Composite Materials
‣ Thermoplastics Pipes And Fittings - Vicat Softening Temperature
‣ Unplasticized Polyvinyl Chloride (Pvc-U) Pipes – Dichloromethane Resistance At Specified Temperature
• Consultancy
• Training

Plastics Piping Systems-Polyethylene (Pe) Pipes- Test Method For The Resistance To Internal Pressure After Application Of Squeeze-Off (TS ISO 34-1)

In this test, the tear strength of the material is determined. Rubber, vulcanized or thermoplastics are tested using Method B Procedure A in this test. (An angle test peice without nick)