Test: Determination of Dimensions (TS EN ISO 3126)

• Test
‣ Determination of Density
‣ MFR
‣ OIT
‣ Determination of Carbon Black
‣ Pigment or Carbon Black Dispersion
‣ Determination of Tensile Properties
‣ Resistance to Internal Pressure
‣ Determination of Volatile Content
‣ Determination of Dimensions
‣ Determination of Longi. Reversion
‣ Oven Test
‣ Determination of Ring Stiffness
‣ Determination of Ring Flexibility
‣ Resistence to External Blows
‣ Determination of the tensile strength and failure mode of test pieces from a butt-fused joint
‣ Peel Decohesion Test for Polyethylene (PE) Electrofusıon Assemblies Of Nominal Outside Diameter
‣ Crushing Decohesion Test for Polyethlene (PE) Electrofusion Assemblies
‣ Decohesion Test of Polyethylene (PE) Saddle Fusion Joints-Evaluation of Ductility of Fusion Joint Interface by Tear Test
‣ Tightness Tests of Valves
‣ Determination of Resistance to Rapid Crack Propagation (RCP)
‣ Determination of Resistance to Crack Propagation
‣ Carbon Black Content In Olefin Plastics
‣ Metallic Materials-Tensile Testing
‣ Plastics Piping Systems – Crosslinked Polyethylene (Pe-X) Pipes – Determination Of Degree Of Crosslinking By Solvent Extraction
‣ Plastics Piping And Ducting Systems – Injection- Moulded Thermoplastics Fitting – Methods For Visually Assessing The Effects Of Heating
‣ Plastics Piping Systems-Polyethylene (Pe) Pipes- Test Method For The Resistance To Internal Pressure After Application Of Squeeze-Off
‣ Determinatıon Of Tear Strenght
‣ Plastics And Ebonite – Determination Of Indentation Hardness By Means Of A Durometer (Shore Harness)
‣ Determination Of Hardness - Part 7: Apparent Hardness Of Rubbercovered Rollers By Shore Type Durometer Method
‣ Gully Tops And Manhole Tops For Vehicular And Pedestrian Areas - Part 1: Definitions, Classification, General Principles Of Design, Performance Requirements And Test Methods
‣ Gully Tops And Manhole Tops For Vehicular And Pedestrian Areas - Part 2: Gully Tops And Manhole Tops Made Of Cast Iron
‣ Gully Tops And Manhole Tops For Vehicular And Pedestrian Areas - Part 5: Gully Tops And Manhole Tops Made Of Composite Materials
‣ Thermoplastics Pipes And Fittings - Vicat Softening Temperature
‣ Unplasticized Polyvinyl Chloride (Pvc-U) Pipes – Dichloromethane Resistance At Specified Temperature
• Consultancy
• Training

DETERMINATION OF DIMENSIONS (TS EN ISO 3126)

This standard covers the measurement and / or determination of the dimensions of plastic pipes and fittings and the accuracy of measurements. This test method covers the procedures of measuring diameters, lengths, stiffnesses and wall thicknesses to check conformity to geometric boundaries.