Test: Oven Test (TS ISO 12091)

• Test
‣ Determination of Density
‣ MFR
‣ OIT
‣ Determination of Carbon Black
‣ Pigment or Carbon Black Dispersion
‣ Determination of Tensile Properties
‣ Resistance to Internal Pressure
‣ Determination of Volatile Content
‣ Determination of Dimensions
‣ Determination of Longi. Reversion
‣ Oven Test
‣ Determination of Ring Stiffness
‣ Determination of Ring Flexibility
‣ Resistence to External Blows
‣ Determination of the tensile strength and failure mode of test pieces from a butt-fused joint
‣ Peel Decohesion Test for Polyethylene (PE) Electrofusıon Assemblies Of Nominal Outside Diameter
‣ Crushing Decohesion Test for Polyethlene (PE) Electrofusion Assemblies
‣ Decohesion Test of Polyethylene (PE) Saddle Fusion Joints-Evaluation of Ductility of Fusion Joint Interface by Tear Test
‣ Tightness Tests of Valves
‣ Determination of Resistance to Rapid Crack Propagation (RCP)
‣ Determination of Resistance to Crack Propagation
‣ Carbon Black Content In Olefin Plastics
‣ Metallic Materials-Tensile Testing
‣ Plastics Piping Systems – Crosslinked Polyethylene (Pe-X) Pipes – Determination Of Degree Of Crosslinking By Solvent Extraction
‣ Plastics Piping And Ducting Systems – Injection- Moulded Thermoplastics Fitting – Methods For Visually Assessing The Effects Of Heating
‣ Plastics Piping Systems-Polyethylene (Pe) Pipes- Test Method For The Resistance To Internal Pressure After Application Of Squeeze-Off
‣ Determinatıon Of Tear Strenght
‣ Plastics And Ebonite – Determination Of Indentation Hardness By Means Of A Durometer (Shore Harness)
‣ Determination Of Hardness - Part 7: Apparent Hardness Of Rubbercovered Rollers By Shore Type Durometer Method
‣ Gully Tops And Manhole Tops For Vehicular And Pedestrian Areas - Part 1: Definitions, Classification, General Principles Of Design, Performance Requirements And Test Methods
‣ Gully Tops And Manhole Tops For Vehicular And Pedestrian Areas - Part 2: Gully Tops And Manhole Tops Made Of Cast Iron
‣ Gully Tops And Manhole Tops For Vehicular And Pedestrian Areas - Part 5: Gully Tops And Manhole Tops Made Of Composite Materials
‣ Thermoplastics Pipes And Fittings - Vicat Softening Temperature
‣ Unplasticized Polyvinyl Chloride (Pvc-U) Pipes – Dichloromethane Resistance At Specified Temperature
• Consultancy
• Training

Oven Test (TS ISO 12091)

An experiment used to determine the homogeneity of the effects of a fired heating on the irregular walls of profiled thermoplastic pipes. This method is not used to ensure that the outer surfaces of the tubes are properly tested.
A pipe part of a predetermined length is heated to a certain temperature and a certain temperature. After the heating process the pipe surfaces are checked. Every physical defect, such as cracks, bubbles, or cracks, is noted. Cracks and bubbles are expressed as a percentage of the wall thickness. Wall separation is expressed as a percentage of the pipe periphery.